HP ProLiant Gen8 Troubleshooting Guide Volume II: Error Messages

HP Virtual Connect errors 223
6021 - Profile has PXE enabled on a non-primary Flex-10 NIC
Severity: MAJOR
Description: PXE is enabled on an Ethernet connection in a profile that is mapped to a non-primary physical
function on a Flex-10 NIC. The current Flex-10 implementation does not allow PXE booting on any but the first
physical function on a Flex-10 NIC port.
Possible cause: PXE is enabled on an Ethernet connection that is mapped to the second, third, or fourth
physical function on a Flex-10 NIC.
Action: Use the GUI to edit the profile and disable PXE on any connections that show PXE is not supported on
them.
6030 - Profile could not be assigned to powered up server
Severity: MAJOR
Description: A profile was changed or assigned and some configuration required that the server be powered
off to make the change. For example, if the number of Ethernet connections is changed for a profile that is
assigned to a server with Flex-10 NICs, then the server must be powered off.
Possible causes:
• A user action results in a profile that requires the server be powered off to make the change or initially
assign or remove the profile.
• VCM restarts and detects a powered on server that has a profile assigned to the bay and the profile
needs to make a change on the server that requires it to be powered off.
Action: Power down the server and retry the change.
Ethernet Network events (7000-7999)
7012 - Enet Network state FAILED
Severity: CRITICAL
Description: The VC Enet Network lost all uplink connectivity because of lack of configured ports or all
configured ports are in a bad state or because a bad or incompatible transceiver was inserted.
Possible causes:
• All of the uplink ports associated with the network are unlinked.
• The user disables all the uplink ports associated with a non-shared network.
• The user disables all the uplink ports in a shared uplink set associated with a shared network.
Action:
• Connect the uplink ports.
• Enable the uplink ports associated with a non-shared network.
• Enable the uplink ports in a shared uplink set associated with a shared network.
7014 - Enet Network state DISABLED
Severity: MAJOR