HP ProLiant Gen8 Troubleshooting Guide Volume II: Error Messages

HP ProLiant server errors 56
230 - DIMM Configuration Error - Processor X, Channel Y
- Only 2 DIMMs can be installed on a channel containing Quad-Rank DIMM(s).
- System Halted!
Audible beeps: Repeating long beep
Possible cause: There are too many DIMMs installed on a channel containing Quad Rank DIMMs.
Action: Ensure there are only two DIMMs installed on the channel.
231 - DIMM Configuration Error
- No memory is available. If DIMMs are installed, verify that the corresponding processor is installed. - System Halted!
Audible beeps: Repeating long beep
Possible cause: No DIMMs are installed in the system or no DIMMs are installed for which there is a
corresponding processor.
Action: Install DIMMs or verify there is a corresponding processor for the installed DIMMs.
232 - Memory initialization error - Processor X, DIMM Y failed.
- No usable memory detected. - System Halted!
Audible beeps: Repeating long beep
Possible cause: All of the installed memory failed the memory test.
Action: Replace memory
233 - DIMM initialization Error - Memory access locked by LT.
Audible beeps: Repeating long beep
Possible cause: Memory access is locked by TXT.
Action: Contact HP support.
234 - DIMM Initialization Error - Receive Enable error. Cannot train memory.
Audible beeps: Repeating long beep
Possible cause: The system receives a Receive Enable error during memory training.
Action: Contact HP support.
235 - DIMM Configuration Error - Processor X, Channel Y
- Only 2 DIMMs can be installed on a channel with UDIMMs. - System Halted!
Audible beeps: Repeating long beep
Possible cause: A channel with UDIMMs has more than two DIMMs installed.
Action: Ensure the correct number of DIMMs is installed.
236 - DIMM Configuration Error - Processor X, DIMM Y
- Ultra-Low Voltage (1.25V) DIMMs not supported. - System Halted!
Audible beeps: Repeating long beep