HP ProLiant Gen8 Troubleshooting Guide Volume II: Error Messages

HP ProLiant server errors 83
1779-Slot X Drive Array - Replacement drive(s) detected OR previously failed drive(s)
now appear to be operational:...
...Port X Box Y Bay(s) Z
Restore data from backup if replacement drive(s) have been installed.
Audible Beeps: None
Possible Cause: More drives failed (or were replaced) than the fault-tolerance level allows. The array cannot
be rebuilt. If drives have not been replaced, this message indicates an intermittent drive failure.
Action: Be sure the system is always powered up and down correctly:
• When powering up the system, all external storage systems must be powered up before (or at the same
time as) the server.
• When powering down the system, the server must be powered down before powering down any
external storage systems.
1779-Slot X Drive Array - Logical drive(s) previously failed...
...Select "F1" to continue with logical drives disabled
Select "F2" to accept data loss and to re-enable logical drives
(followed by one of the following:)
* Logical drive(s) disabled due to possible data loss.
* Logical drive(s) reenabled.
Restore data from backup if replacement drive(s) have been installed
Audible Beeps: None
Possible Cause: Previously failed logical drives are attached to the controller.
Action: Do one of the following:
• To continue with logical drives disabled, select F1.
• To accept data loss and to re-enable the logical drives, select F2.
1783-Slot X Drive Array Controller Failure...
followed by one of the following:)
...* [Board ID not programmed (replace ROMs or replace controller)]
* [I2C read error]
* [Image checksum error]
* [Inconsistent volume count]
* [Inconsistent volume count (B)]
* [Unexpected hardware revision – hardware rework needed]
* [Unsupported Flash ROM type installed]
* [iLO communication mechanism self-test error]
* [PROGRAM BUG! Insufficient padding bytes (cmd=##h)]
* [Incorrect EEPROM type]
* [Init failure (cmd=##h, err=##h)]
* [Command failure (cmd=##h, err=##h)]
* [Self-test failure (ErrCode=####h)]
* [I2C NVRAM reconfiguration failure]
* [PCI bridge missing]
* [PCI bridge disabled; check System ROM version]