HP ProLiant DL380p Gen8 Carrier-Grade Server Read Before Install Carrier-Grade Instructions

3. Select the Temperatures tab.
If the temperature thresholds of sensor 01–Inlet Ambient appear as shown below, the
switch is set correctly.
Incorrect Thresholds
If the thresholds do not show up correctly, ensure the #10 position was set correctly. If incorrectly
set, reset the system maintenance switch SW2 to the factory defaults as described in the HP Proliant
DL380p Gen8 Server Maintenance and Service Guide at the following HP website:
http://www.hp.com/go/hpsc
Enter a product name, or select Servers, and then selectProliant /tc series servers. Select your
product, and then click Manuals under Knowledge Base. You may need to click through more than
one page of manuals to find a specific one.
After you reset the switch settings to the factory defaults, repeat the procedure above on how to
verify the system maintenance switch setting.
8 Changing the Settings on the System Maintenance Switch