HP ProLiant DL380p Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 55
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove any attached network cables.
4. Extend ("Extend the server from the rack" on page 29) or remove ("Remove the server from the rack" on
page 30) the server from the rack.
5. Remove the access panel ("Access panel" on page 34).
6. Remove the primary PCIe riser cage ("PCIe riser cage (primary)" on page 37).
7. Loosen the thumbscrew.
8. Remove the existing FlexibleLOM.
Pull the FlexibleLOM toward the front of the server while removing it, to avoid catching it on the rear
chassis.