HP ProLiant DL380p Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 56
To replace the component:
1. Firmly seat the FlexibleLOM in the slot, and then tighten the thumbscrew.
2. Install the PCIe riser cage ("PCIe riser cage (primary)" on page 37).
3. Install the access panel ("Access panel" on page 34).
4. Slide the server into the rack.
5. Connect the LAN segment cables.
6. Connect each power cord to the server.
7. Connect each power cord to the power source.
8. Power up the server.
SFF hard drive cage
To remove the component:
1. Power down the server (on page 28).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend ("Extend the server from the rack" on page 29) or remove ("Remove the server from the rack" on
page 30) the server from the rack.
4. Remove the access panel ("Access panel" on page 34).
5. Remove all hot-plug hard drives ("Hot-plug drive" on page 40).
6. Remove the air baffle ("Air baffle" on page 35).
7. Remove the fan cage ("Fan cage" on page 54).
8. Disconnect all cables from the hard drive backplane.