HP ProLiant DL380p Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 70
IMPORTANT: Processor socket 1 must be populated at all times or the server does not function.
To remove the processor:
1. Power down the server (on page 28).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend ("Extend the server from the rack" on page 29) or remove ("Remove the server from the rack" on
page 30) the server from the rack.
4. Remove the access panel ("Access panel" on page 34).
5. Remove the air baffle ("Air baffle" on page 35).
6. Remove the heatsink ("Heatsink" on page 67).
7. Open each of the processor locking levers in the order indicated, and then open the processor retaining
bracket.