ProLiant DL580 Generation 5 Maintenance and Service Guide

Removal and replacement procedures 31
5.
Firmly holding the processor memory module, press the release buttons and pull the module out of
the server.
6. Remove the processor memory module cover.
To replace the component, reverse the removal procedure.
Hard drive
CAUTION: Always power down the server if the boot partition resides on the drive you are
replacing or if you are replacing the only drive in the server.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
1. Determine the status of the hard drive from the hot-plug hard drive LEDs ("SAS hard drive LEDs" on
page 78).