ProLiant DL580 Generation 5 Maintenance and Service Guide

Removal and replacement procedures 41

Press the locking latch, and push the Systems Insight Display assembly through the front of the server.

8. Remove the DVD drive (on page 41) from the Systems Insight Display assembly, and then install the

drive into the new assembly.

9. To replace the component, reverse the removal procedure. If a SATA DVD drive is installed, before

installing the Systems Insight Display assembly into the server, route the cable through the open bay,

and then connect the cable to the rear of the DVD drive.

DVD drive

CAUTION: When routing cables, always be sure that the cables are not in a position where

they can be pinched or crimped.

1. Power down the server (on page 26).

2. Extend or remove the server from the rack ("Extending the server from the rack" on page 27).

3. Remove the access panel ("Removing the access panel" on page 28).

4. Remove the tape drive blank (on page 32), if installed.

5. Remove the Systems Insight Display assembly (on page 40).

6. Eject the DVD drive using one of the following procedures: