XenServer Administrator's Guide 4.1.0

Command line interface
91
Parameter Name Description Type
config parameter includes the key/value
pair auto_poweron: true
start-time Timestamp of the date and time that the
metrics for the VM were read, in the form
yyyymmddThh:mm:ss z, where z is the
single-letter military timezone indicator, for
example, Z for UTC (GMT)
read only
install-time Timestamp of the date and time that the
metrics for the VM were read, in the form
yyyymmddThh:mm:ss z, where z is the
single-letter military timezone indicator, for
example, Z for UTC (GMT)
read only
memory-actual The actual memory being used by a VM read only
VCPUs-number The number of virtual CPUs assigned to
the VM
For a paravirtualized Linux VM, this
number can differ from VCPUS-max and
can be changed without rebooting the
VM via the vm-vcpu-hotplug command.
See Section 5.4.22.27, “vm-vcpu-hotplug”.
Windows VMs always run with the number
of vCPUs set to VCPUs-max and must be
rebooted to change this value.
Note that performance will drop sharply if
you set VCPUs-number to a value greater
than the number of physical CPUs on the
XenServer Host.
read only
VCPUs-utilisation A list of virtual CPUs and their weight read only map parameter
os-version the version of the operating system for the
VM
read only map parameter
PV-drivers-version the versions of the paravirtualized drivers
for the VM
read only map parameter
PV-drivers-up-to-date flag for latest version of the paravirtualized
drivers for the VM
read only
memory memory metrics reported by the agent on
the VM
read only map parameter
disks disk metrics reported by the agent on the
VM
read only map parameter
networks network metrics reported by the agent on
the VM
read only map parameter
other other metrics reported by the agent on the
VM
read only map parameter
guest-metrics-last-
updated
timestamp when the last write to these
fields was performed by the in-guest
agent, in the form yyyymmddThh:mm:ss
read only