Configuring Arrays on HP Smart Array Controllers Reference Guide

HP Array Configuration Utility 90
Error code Error message Comment or clarification
slot for an available, active controller, or the
controller is not available.
2866
Failure opening capture file <text> —
2867
Failure opening input file <text> —
2868
Failure opening error file <text> —
2877
There are no suitable spares available ACU found no drives that could be used as spares
for the specified array.
2880
Invalid Physical Disk Type Specified —
2882
Invalid MNP delay The specified value for MNP delay is invalid.
3000
Invalid Option
The value of the option supplied to this parameter is
invalid.
3002
Command Failed The controller returned an error for a command.
3003
License Key Delete Failed ACU is unable to delete the license key.
3004
Invalid Sector Size —
3005
Cannot delete Array —
3006
Invalid Number of Parity Groups —
3007
Chassis name is too long —
3008
Chassis name is already in use Another controller is already using the entered
chassis name.
3009
Auto Configure failed The Auto Configure mode was unable to complete
auto configuration.
3010
Cannot extend logical drive, not enough
free space for the requested size
—
3011
Cannot extend logical drive, requested size
is too small
—
3012
Cannot specify both SIZE and SHRINKSIZE The input file cannot specify both a SIZE and
SHRINKSIZE parameter.
3013
Cannot shrink Array The array shrink operation was not successful.
3014
Cannot move Array The array move operation was not successful.
3015
Invalid operation - Advanced Pack support
required
The requested operation requires a valid license key
to be entered.
3016
Spare drives cannot be specified by a count
in Reconfigure mode
When in Reconfigure mode, the requested spare
drives must be specified by their addresses. A simple
count cannot be used.
3017
Disk drives cannot be specified by a count in
Reconfigure mode
When in Reconfigure mode, the requested data
drives must be specified by their addresses. A simple
count cannot be used.
3018
Invalid number of physical disks —
3019
Cannot create Array - no physical disks
specified
ACU cannot create an array unless physical disks
are specified in the input file DRIVE parameter.
3020
SSP must be enabled in order to perform this
operation
For the specified operation, ACU requires SSP to be
supported and enabled.
3021
Invalid connection name —