HP ProLiant Storage Server User Guide (440584-005, June 2008)

1. On the remote client machine open Internet Explorer and enter https:// and the serial number
of the storage server followed by a hyphen (-), and then:3202. For example,
https://D4059ABC3433-:3202. Press Enter.
NOTE:
If you are able to determine the IP address from your DHCP server, you can substitute the
IP address for the serial number and hyphen (-). For example: 192.100.0.1:3202.
2. Click OK on the Security Alert prompt.
3. Log on to the HP ProLiant Storage Server Management console with the default user name
administrator and the password hpinvent.
NOTE:
You can change the administrator name and password when you configure the server using
the Rapid Startup Wizard.
4. To complete network configuration using the Rapid Startup Wizard, see
“Configuring the server on the network” on page 30.
IMPORTANT:
If you are using the remote browser method to access the HP Storage Server Management console and
Rapid Startup Wizard, always close the remote session before closing your Internet browser. Closing the
Internet browser does not close the remote session. Failure to close your remote session impacts the limited
number of remote sessions allowed on the storage server at any given time.
Connecting to the storage server permits you to access the HP Storage Server Management console
(Figure 2). From the console, you can access snap-ins that allow complete server system management.
HP ProLiant Storage Server 25