HP LO100c Remote Management Card Installation Instructions for HP ProLiant ML115 Server

HP LO100c Remote
Management Card
Installation Instructions
for HP ProLiant ML115 Server
Read instructions completely before beginning installation procedure.
Legal notices
© Copyright 2006 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to chan
ge without notice. The
only warranties for products and services
are set forth in the express warranty
statements accompanying such products
and services. Nothing herein should
editorial errors or omissions contained herein.
First edition: December 2006
Overview
This document contains instructions for installing an HP ProLia
nt
ML115 LO100c remote management card into an HP ProLiant
ML115 server.
NOTE:
For more information on preparing the server for
installation, refer to the user
guide included on the Support
CD.
Kit Contents
• HP ProLiant ML115 LO100c Remote Management Card
•
HP LO100c Remote Management ca
rd Installation Instructions
Important Safety Information
Refer to the Important Safety Information
document included with the
server.
WARNING!
Electrostatic discharge (ESD) can damage
electronic components. Be sur
e you are properly grounded
(earthed) before beginning an
y installation procedure.
Installation Guidelines
This installation is to be performed by qualified individuals who are
knowledgeable of the procedures, precautions, and hazards
associated with equipment containing hazardous energy circuits.
Figure 1 HP LO100c Remote Management Card Connector Loca
tion
• PCI-E x 8 connector
CAUTION: PCI-E x 8 Connector is only for HP ProLiant
ML115 LO100c remote
management card.
Installing the Card
1. Back up the server data.
2.
Shut down the operating system in an orderly manner, as
directed in the operating system instructions.
3.
If the server is on, press the power button to power down the
server.
4.
Disconnect all power cords.
5.
Remove the access panel.
6. Loosen the screw to remove the IPMI card bracket dummy from
the chassis.
7. Press the card straight down into the expansion slot on the
system board. (step one in figure 2)
8. Be sure the card is at the corre
ct position and the bracket on
the card is aligned with the open slot on the rear of the chas
sis.
9. Fasten the expansion card brac
ket on the rear panel with
screw. (step two in figure 2)
Figure 2 Installing the Card
10. Replace the access panel.
11.
Reconnect all power cords.
CAUTION: The LAN port on the HP LO100c remote
management card is dedica
ted to LO100c 10/100 LAN
Management Port.
Part number: 441899-00 1
be constit
u
ting a
n additional warranty.
HP s
hall not be liable for te
chnical or