ZCR Option Kit Installation Sheet

ManualsBrandsHP ManualsServerHP ProLiant ML150 Server

HP CONFIDENTIAL Writer: Pauline Tsai Codename:Stone Soup Part Number: 355750-001 Last Saved On: 12/2/03 11:54 AM

ZCR Option Kit

Installation Sheet

for HP ProLiant ML150 Servers

Read instructions completely before

beginning installation procedure.

Hewlett-Packard Company shall not be liable for technical or editorial errors

or omissions contained herein. The information in this document is provided

“as is” without warranty of any kind and is subject to change without notice.

The warranties for HP products are set forth in the express limited warranty

statements accompanying such products. Nothing herein should be

construed as constituting an additional warranty.

Printed in China

ZCR Option Kit Installation Sheet

First Edition (December 2003)

Part Number 355750-001

355750- 001

Overview

Use these instructions to install the Zero Channel RAID (ZCR)

card in the HP ProLiant ML150 server. For additional information

on installing and removing hardware options, refer to the

documentation that shipped with the server.

Warnings and Cautions

WARNING: To reduce the risk of personal injury from

hot surfaces, allow the internal system components to

cool before touching them.

WARNING: Eliminate the risk of electric shock by

removing all AC power from the system before

installing or replacing any non-hot-plug hardware

option to the server. Disconnect all power cords to

completely remove power from the server.

CAUTION: Properly ground yourself before beginning any

installation procedure. Electrostatic discharge can damage

electronic components.

Preparing the Server for Installation

Before installing the ZCR card:

1. Back up all server data.

2. Power down the server, and disconnect the power cord and any

external cables to completely remove power from the server.

Refer to the documentation that shipped with the server for the

detailed information.

3. Open the upper bezel, lower bezel, and side panel before

removing the internal components. Refer to the documentation

that shipped with the server for the detailed information.

NOTE: The server needs to have at least two hard drives installed

for the RAID function.

Installing the ZCR Card

Summary of content (2 pages)

PAGE 1
Overview ZCR Option Kit Installation Sheet Use these instructions to install the Zero Channel RAID (ZCR) card in the HP ProLiant ML150 server. For additional information on installing and removing hardware options, refer to the documentation that shipped with the server. Warnings and Cautions WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system components to cool before touching them.
PAGE 2
5 NOTE: The ZCR card must be inserted in the PCI slot 2 (green color). 3 1. Turn on the monitor and the HP server. During the startup process, pay careful attention to the messages that display on your screen. 2. When the following message displays on your screen, press the Ctrl-A keys simultaneously (this message displays for only a few seconds): Hit for Adaptec Setup 3. When the blue-background screen displays, press the Alt-R keys simultaneously to pull down the RAID menu. 4.