HP ProLiant ML310 G3 Storage Server Administration Guide (WSS R2 version, March 2006)

2. If you intend to conﬁgure a remote server, conﬁrm that the ACU Execution Mode is set to remote

service.

3. Op en the browser, either locally (on the host) or on the remote server.

4. Enter the following text into the browser address ﬁeld (where servername isthenameorIPaddressof

the host):

http://servername:2301

The login screen for the System Management homepage opens.

5. Log in. The System Management homepage opens.

6. Click Array Conﬁguration Utility on the left side of the window. The ACU opens and identiﬁes the

controllers that are connected to the system. This process could take a minute or two.

Some ACU guidelines to consider:

• Do not modify Array A off of the Smart Array controller, because it contains the storage server

operating system.

• Spanning more than 14 disks with a RAID 5 volume is not recommended.

• Designate spares for RAID sets to provide greater protection against failures.

• RAI D sets cannot span controllers.

• A single array can contain multiple logical drives of varying RAID settings.

• Extending and expanding arrays and logical drives is supported.

• RAID migration is not supported.

The HP Array Conﬁguration Utility User Guide is available for download at h

ttp://

h200002.ww w2.hp.com/bc/docs/support/SupportManual/c00294139/c00294139.pdf.

HP Storage M anager

The HP Sto

rage Manager supports the SATA R AID controller and SATA hard disk drives installed

on the storage server.

NOTE:

Not all SATA -based storage servers use hardware RAID with the HP Storage Manager.

File server management