HP ProLiant ML310e Gen8 v2 Server Maintenance and Service Guide

Removal and replacement procedures 29
1.
Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the tower bezel (on page 26).
4. Remove the access panel ("Access panel" on page 28).
5. Remove the air baffle.
To replace the component, reverse the removal procedure.
Drive blank or carrier
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Unlock and open the tower bezel ("Unlock the tower bezel" on page 26).
2. Do one of the following: