HP ProLiant ML310e Gen8 v2 Server Maintenance and Service Guide

Removal and replacement procedures 38
7.
Press and hold the release latch, and then remove the fan module.
To replace the component, reverse the removal procedure.
Rear system fan
To remove the component:
1. Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the tower bezel (on page 26).
4. Remove the access panel ("Access panel" on page 28).
5. Remove the air baffle ("Air baffle" on page 28).
6. Remove any existing expansion board that blocks access to the rear system fan connector.
7. Disconnect the fan cable.