HP ProLiant ML310e Gen8 v2 Server Maintenance and Service Guide

Removal and replacement procedures 53
b.
Disconnect each power cord from the server.
3. Unlock and open the tower bezel ("Unlock the tower bezel" on page 26).
4. Remove the access panel ("Access panel" on page 28).
5. Remove the air baffle ("Air baffle" on page 28).
6. Disconnect the power supply cables from the drive cage and system board.
7. Remove the EMI shield from the lower media bay.
8. Remove the optical drive from the upper media bay.
9. Remove the hot-plug power supplies.
10. Remove the RPS backplane module.
11. Remove the power supply cage.
To replace the component, reverse the removal procedure.
System board
CAUTION: To avoid ESD damage, when removing electrostatic-sensitive components from the
failed system board, place the components on a static-dissipating work surface or inside separate
antistatic bags.
To remove the system board:
1. Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the tower bezel (on page 26).
4. Remove the access panel ("Access panel" on page 28).
5. Remove the air baffle ("Air baffle" on page 28).
6. Remove the rear system fan.