Compaq ProLiant ML330 Generation 2 Server Maintenance and Service Guide

Removal and Replacement Procedures
Hard Drives
To remove a hard drive from the hard drive compartment:
1. Complete the preparation procedures. Refer to “Preparation Procedures” earlier in this
chapter.
2. Remove the front bezel. Refer to “Front Bezel” earlier in this chapter.
3. Remove the access panel. Refer to “Access Panel” earlier in this chapter.
4. Disconnect the power and data cables from the back of all devices in the hard drive
compartment.
5. Remove the hard drive compartment. Refer to “Removing a Hard Drive Compartment”
earlier in this chapter.
6. Using a Phillips screwdriver, remove the two screws on each side of the drive to be
removed (1), and then gently pull the drive out of the drive bay (2).
2
1
1
Figure 2-15: Removing a hard drive
To replace the hard drive, reverse steps 2 through 6.
Compaq ProLiant ML330 Generation 2 Server Maintenance and Service Guide 2-19
COMPAQ CONFIDENTIAL Codename: Mimic/Reaper Part Number: 234832-003 Last Saved On: 11/25/02 10:18 AM