Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide

Hardware Options Installation 3-11
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 234833-001 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 5/23/01 3:48 PM
3. Remove the three shipping screws, press the tabs on each side of the
drive compartment, and then pull the drive compartment from the
chassis as shown in Figure 3-5.
4. Remove the two screws on each side of the drive , and then gently pull
the drive out of the drive bay
as shown in Figure 3-9.
2
1
1
Figure 3-9. Removing a hard drive
5. Slide the drive compartment back into the chassis, and then replace the
three hard drive compartment shipping screws.
6. Connect the power and data cables to the back of all devices.
7. Replace the access panel and the front bezel.
8. Restore power to the server.