Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide

Cabling Guidelines 4-7
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 234833-001 File Name: e-ch4 Cabling Guidelines.doc Last Saved On: 5/22/01 2:42 PM
Cabling a Smart Array Controller
Many configurations are possible when multiple SCSI controllers are added.
This section outlines the cabling procedure for an installed Smart Array
Controller. Refer to the Smart Array Controller option documentation for
further installation information.
The following steps outline the cabling procedure for the Smart Array
Controller:
1. Install the Smart Array Controller as instructed in the option kit
documentation.
2. If hard drives are not already installed, follow the appropriate steps in
Chapter 3, “Hardware Options Installation,” and then install the device.
3. Locate the cable connected to the SCSI channel on the Server Feature
Board.
4. Remove the cable from the SCSI channel.
Figure 4-5. Removing the SCSI cable from the Server Feature Board