Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide

Cabling Guidelines 4-13
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 234833-001 File Name: e-ch4 Cabling Guidelines.doc Last Saved On: 5/22/01 2:42 PM
4. Install the next available power connector to the hard drive or ATA
device.
Cabling an ATAPI Tape Drive
The following steps detail the procedure for cabling an optional ATAPI tape
drive:
1. Install the tape drive into removable media bay 2 by following steps 1
through 5 under “Installing a Tape Drive” in Chapter 3, “Hardware
Options Installation.”
2. Connect an ATA cable to the primary IDE channel on the system
board
.
See “System Board Components” in Chapter 1, “Server Features,” for
the location of the primary IDE channel.
3. Secure the cable connector labeled “Device 1” to the tape drive and
the cable connector labeled “Device 0” to the CD-ROM drive
.
1
3
2
Figure 4-10. Cabling an ATAPI tape drive
4. Install the next available power connector to the tape drive.