Compaq ProLiant ML330 Generation 2

Compaq ProLiant ML330 G2 Service Overview 14

Rev. 1.0 Page 14 of 20

Installation Procedures

Processors

The Proliant ML330 G2 comes standard with an Intel Pentium III processor. Its corresponding

Processor Power Module (PPM) is integrated on the system board. An optional processor and

PPM can be installed.

Important:

If you install more than one processor, both processors must be the same type and speed. The

CPU1 socket must always be populated before the CPU2 socket.

Table 5: Processor Installation

Step Action

1. Verify that all critical data has been backed up.

2. Ensure the server has the most current ROM version. To update the ROM, visit:

http://www.compaq.com/support/files/server/us

Caution: Failure to flash the ROM before installing a new processor can cause system

failure.

3. Remove the Access Panel. (Refer to Setup and Installation Guide, listed under

References.)

4. Remove the internal fan baffle that covers the processor sockets by unseating the baffle

and sliding it out and away from the chassis.

5. Locate the processor sockets and PPM 2 slot:

Item

Description