Compaq ProLiant ML330 Generation 2

Compaq ProLiant ML330 G2 Service Overview 17
Rev. 1.0 Page 17 of 20
Installing the PPM for Processor 2
Perform the following steps to install the PPM corresponding to the second processor:
Table 6: Processor Power Module (PPM) Installation
Step Action
1. Align the PPM with the PPM slot.
2. Slide the PPM into the slot  until the latches snap securely into place :
Memory
The ProLiant ML330 G2 supports registered 133MHz ECC SDRAM DIMMs. The memory bus
and controller are not compatible with older 100MHz DIMMs.
Standard memory in all ML330 G2 models is a single 128MB DIMM. Memory can be expanded
one DIMM at a time in the four memory sockets provided.
Integrated ATA RAID Troubleshooting Tips
Drive Connection
■ If you have two drives, connect one per channel. The performance of the array is best
with one drive per channel, with both drives residing on the master connection of their
channel.
■ Use the same type of drives or drives with similar speed and capacity.
■ Do not use dissimilar drives on the same channel.
■ Always use 80-conductor Ultra ATA cables.
■ Use appropriate jumper settings
3
.
■ Do not connect any ATAPI devices (e.g., CD-ROM, ZIP, or LS120 drive) to the ATA
controller.
3
Refer to Appendix E, “LED Indicators, Switches, and Jumpers” in the Setup and Installation Guide. (See References.)
2
1
2