Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

D-10 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: j-appd Troubleshooting.doc Last Saved On: 12/27/00 3:30 PM
Table D-4
Problems After Initial Boot
continued
Problem Possible Cause Possible Solution
Server
cannot load
operating
system.
continued
Installation problem
occurred.
Refer to your operating system documentation and to the
SmartStart release notes.
Primary hard drive
controller installation is
incorrect.
Run the setup utility for your server and correct this
problem.
For the ProLiant ML330 server, press F10 to run the
BIOS Setup utility.
For the ProLiant ML330e server, press F9 to run the
ROM Based Setup Utility (RBSU)
Refer to Chapter 5 for complete instructions on the use of
the setup utilities.
Hard drive controller
order is incorrect.
Run the setup utility for your server and correct this
problem.
For the ProLiant ML330 server, press F10 to run the
BIOS Setup utility.
For the ProLiant ML330e server, press F9 to run the
ROM Based Setup Utility (RBSU)
Refer to Chapter 5 for complete instructions on the use of
the setup utilities.
Encountered problem
after new hardware was
added to the system.
Refer to the documentation provided with the hardware.
Remove the new hardware.
Problem was
encountered with
hardware added to a
new system ordered with
a factory-installed
operating system (where
available).
You must complete the factory-installed operating system
software installation BEFORE adding new hardware to the
system.
Be sure that you are following the instructions provided in
the Factory-Installed Operating System Software
Installation Guide.
Remove the new hardware and complete the software
installation. Then, reinstall the new hardware.