Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

E-2 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: k-appe LEDs & Switches.doc Last Saved On: 12/27/00 3:34 PM
This appendix includes the following topics:
■ LEDs
There are several LEDs located on the front, the back, and the inside of
your server. These LEDs can communicate the current status of your
server components and operations, thus aiding you in diagnosing the
problem. You are provided with an illustration of the location of each
LED on your server, as well as an explanation of uses and possible
statuses in the following section.
■ Switches
There are three switchbanks in your server. Some switch settings may
need to be changed from time to time and can cause problems if they are
not correctly set. Some switches should not be changed for any reason.
You are provided with a list of all switches, a description of what each
setting means, and an illustration of where each may be found inside
your server.
■ Jumpers
When devices are added to the server, the jumpers on the device may
need to be changed. You are provided with information on jumper
settings for both SCSI and ATA devices.
For troubleshooting information beyond the scope of this guide, both general
and specific to the ProLiant ML330e/ML330 server, see
“Other Information Resources” in Appendix D.