Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

LED Indicators, Switches, and Jumpers E-7
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: k-appe LEDs & Switches.doc Last Saved On: 12/27/00 3:34 PM
System Configuration Switch (SW2)
1 234
on
Figure E-3. System configuration switch (SW2) default settings
Table E-3
System Configuration Switch (SW2) Settings
Important: Clearing nonvolatile RAM (NVRAM) deletes your configuration information. See Chapter 5 for
complete instructions on configuring your server.
Position Default Function Description Settings
1 Off Clear/set up
password
Used to disable
password
Off = Password enabled
On = Password disabled
2 Off Clear CMOS
and NVRAM
Used to clear system
configuration settings
Off = Normal
On = When server is powered up, all
system configuration information is
erased.
3OffROMPaq
disaster
recovery
enable
Used to enable
ROMPaq disaster
recovery mode when
system ROM is
corrupted
Off = Normal server operations
mode
On = ROMPaq disaster recovery
mode
4OffReserved
Note: System Configuration Switch (SW2) position 4 is reserved for Compaq authorized service providers
only. Do not change the specified default setting for this position.