Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

E-8 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: k-appe LEDs & Switches.doc Last Saved On: 12/27/00 3:34 PM
Clearing and Resetting System Password Settings
It may be necessary at some time to clear and reset the system password.
When the system configuration switch position 1 is set to the on position, the
system is prepared to clear the system password:
1. Power down the server.
2. Set the switch at position 1 to the on position.
3. Restart the server, and wait for confirmation.
4. Power down the server.
5. Set the switch at position 1 to the default off position.
6. Restart the server. The password is cleared.
Clearing and Resetting System
Configuration Settings
It may be necessary at some time to clear and reset system configuration
settings. When the system configuration switch position 2 is set to the on
position, the system is prepared to erase all system configuration settings from
both CMOS and NVRAM:
IMPORTANT: Clearing nonvolatile RAM (NVRAM) deletes your configuration information.
Refer to Chapter 5 for complete instructions on configuring your server.
1. Power down the server.
2. Set the system configuration switch position 2 to the on position.
3. Power up the server.
All configuration settings are now erased and all system operations halt.
4. Power down the server.
5. Reset the position 2 switch to the default off position.
6. Power up the server.
7. Reset all system configuration settings:
G For ProLiant ML330 servers, press F10 to run the BIOS Setup utility
G For ProLiant ML330e servers, press F9 to run the ROM Based Setup
Utility (RBSU)