Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

2-6 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: c-ch2 Overview of Server Installation.doc Last Saved On: 12/27/00 3:25 PM
1. After the cables have been connected to the server, you are ready to
power up the ProLiant ML330e/ML330 server. To power up your
server:
a. To release the door latch, press and release the circular indentation
on the left side of the drive bay door
.
b. Swing the drive bay door open .
c. Press the center of the power button on the front of the server .
1
2
3
Figure 2-2. Powering up the server
2. To complete the factory-installed operating system process, follow the
screen instructions.
3. Refer to Chapter 5, “Server Configuration and Utilities,” and the
Compaq Management CD for information about installing the Compaq
Management Agents for your operating system.
4. After verifying your server configuration, back up your system
configuration. Refer to the SmartStart and Support Software CD for
further information on backing up your system configuration.
5. Install any application software.
To install additional options not preinstalled on your server, follow the steps in
Chapter 3.