Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

Hardware Options Installation 3-3
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 12/27/00 3:26 PM
Removing the Front Bezel
To remove the front bezel:
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the front bezel.
1. Follow the steps in “Shutting Down the Server” earlier in this chapter.
2. Push up on the latch at the bottom of the front bezel .
3. Swing the front bezel upward and slide it out and away from the
chassis
.
1
2
Figure 3-1. Removing the front bezel
To replace the front bezel, reverse steps 2 and 3.
NOTE: When replacing the front bezel, make sure that the top hinge points are properly
placed in the chassis before rotating the front bezel into its original position.
NOTE: As a security measure on the ProLiant ML330 server, an intruder alert message (if
enabled) is displayed at startup if the front bezel has been unlatched. Refer to Chapter 5
for information on enabling intruder alert.