Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

Hardware Options Installation 3-5
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 12/27/00 3:26 PM
Removing the Bezel Blanks
To remove a bezel blank from the front bezel:
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the front bezel
1. Remove front bezel. See “Removing the Front Bezel” earlier in this
chapter.
2. On the back of the front bezel, pinch the tabs on each end of the bezel
blank toward each other
, and then push the bezel blank through the
front bezel
.
1
2
Figure 3-3. Removing a bezel blank
To replace a bezel blank, reverse steps 1 and 2.