Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

3-6 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 12/27/00 3:26 PM
Removing a Drive Tray
NOTE: The drive trays in the removable media bays can be used to mount internal
3.5-inch hard drives. The rails mounted inside the drive trays can be removed and used to
mount other devices in the removable media bays.
To remove a drive tray from a removable media bay:
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the access panel.
1. Follow the steps in “Removing the Access Panel” earlier in this chapter.
2. Remove the screws on each side of the drive tray.
3. Gently slide the drive tray out of the front of the chassis.
Figure 3-4. Removing the drive tray
To replace a drive tray, reverse steps 2 and 3.