Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

3-8 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 12/27/00 3:26 PM
Installing a Hard Drive
To install a 3.5-inch hard drive:
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the front bezel.
1. Follow the steps in “Removing the Access Panel” earlier in this chapter.
2. Disconnect the power and data cables from the back of all devices in the
hard drive compartment.
3. Remove the three shipping screws , press the tabs on each side of the
drive compartment
, and then pull the drive compartment from the
chassis
.
1
1
2
3
2
Figure 3-6. Removing the drive compartment