Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

Hardware Options Installation 3-9
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 12/27/00 3:26 PM
4. Configure the device.
G For the ProLiant ML330 server, set the SCSI ID on the drive. You
must manually set the SCSI ID on each device to a unique value in
the range of 0 to 6 for each SCSI bus. Refer to the documentation
provided with the device for instructions on how to set the SCSI ID.
G For the ProLiant ML330e server, make sure that the jumper on the
drive is set to Cable Select so that the primary and secondary drives
are determined by the cable. Refer to Chapter 4 “Cabling
Guidelines” for more information.
5. If applicable, remove all terminating jumpers from third-party SCSI
devices. (Compaq SCSI cables are terminated.)
6. Slide the drive into the drive bay , and then secure with two screws on
each side of the drive compartment
.
1
2
2
Figure 3-7. Installing a 3.5-inch hard drive
7. Slide the drive compartment back into the chassis.