Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

Hardware Options Installation 3-13

Compaq Confidential – Need to Know Required

Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:

Part Number: 173868-002 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 12/27/00 3:26 PM

Installing a Hard Drive into a Removable Media Bay

IMPORTANT: If you are installing a hard drive into a removable media drive bay, you

must use a drive tray. This drive tray can be found in the removable media bay. See

“Removing a Drive Tray” earlier in this chapter.

To install a hard drive using a drive tray:

CAUTION: To prevent damage to equipment or loss of information, make sure

that the server is powered down, all cables are disconnected from the back of

the server, and the power cord is disconnected from the grounded (earthed) AC

outlet before removing the access panel.

1. Follow the steps in “Removing the Access Panel” and “Removing a

Drive Tray” earlier this chapter.

2. Set the drive into the drive tray .

3. Tighten the screws on the bottom of the drive tray to secure the drive

into the drive tray

Figure 3-13. Installing a hard drive into removable media bay drive tray

4. Slide the drive tray into the removable media bay, and then secure with

a screw on each side of the bezel blank.