Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

Hardware Options Installation 3-21
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 12/27/00 3:26 PM
Installing an Expansion Board
To install an expansion board:
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the access panel.
CAUTION: To prevent damage to the system when handling components, see
Appendix B, “Electrostatic Discharge.”
1. Follow the steps in “Removing the Access Panel” earlier in this chapter.
2. From inside the chassis, push the expansion slot cover through the rear
of the chassis.
Figure 3-21. Removing expansion slot cover