Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

Hardware Options Installation 3-23
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 12/27/00 3:26 PM
Interrupt Settings
NOTE: You can reset interrupt settings at any time by running the setup utility, and
choosing “Set Defaults and Exit.”
The setup utility for your server allows you to view and change the interrupts
assigned to each device. However, you may notice that changing the interrupt
of one device changes another device interrupt. For information on the setup
utility used by your server, refer to Chapter 5, “Server Configuration and
Utilities.”
Memory Modules
Technical Information and Important Guidelines for
DIMM Installation
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the access panel.
CAUTION: To prevent damage to the system when handling components, see
Appendix B, “Electrostatic Discharge.”
CAUTION: When handling a memory module, be careful not to touch any of the
contacts. Doing so may damage the module.
When installing DIMMs, you must follow these guidelines:
■ Use only 64-MB, 128-MB, 256-MB, or 512-MB Registered
PC133-MHz ECC SDRAM DIMMs.
■ DIMMs must be industry-standard, 168-pin, PC133-MHz Registered
SDRAM DIMMs. The SDRAM DIMMs must support CAS Latency 3
(CL=3).
■ Do not mix ECC and non-ECC SDRAM DIMMs. If different types of
DIMMs are mixed, the system does not function properly.