Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

Hardware Options Installation 3-29
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: d-ch3 Hardware Options Installation.doc Last Saved On: 12/27/00 3:26 PM
Replacing the Server Feature Board Battery
WARNING: The Server Feature Board contains a lithium battery. There is a risk
of fire and chemical burn if the battery is handled improperly. Do not
disassemble, crush, puncture, short external contacts, dispose of in water or
fire, or expose the battery to temperatures higher than 60°C (140°F).
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the access panel.
CAUTION: Static electricity can damage electronic components of the server.
Before beginning these procedures, be sure that you are discharged of static
electricity by briefly touching a grounded metal object.
To install the new battery:
1. Follow the steps in “Removing the Access Panel” at the beginning of
the chapter.
2. Remove the Server Feature Board from expansion slot 3. See
“Expansion Slots” earlier in this chapter.
3. Slide the battery out of the holder, and then lift the battery away from
the holder.
4. Slide the replacement battery into the proper position with the positive
(+) side up.
Figure 3-27. Replacing the Server Feature Board battery