Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: e-ch4 Cabling Guidelines.doc Last Saved On: 12/27/00 3:27 PM
Chapter 4
Cabling Guidelines
Storage Device Installation Guidelines
This chapter provides an overview of the cabling that resides in the system
chassis of a Compaq ProLiant ML330e/ML330 server. This chapter also
includes information on how to cable SCSI, ATA, and removable media
devices in the system, as well as information about all critical system cabling.
SCSI Cabling (for the ProLiant ML330 Server)
Consider the following guidelines when adding SCSI devices to your
ProLiant ML330 server:
NOTE: For ProLiant ML330e server cabling information, refer to the section
“ATA/100 Cabling” later in this chapter.
■ As a general rule, a maximum of seven devices may be added per
channel. Your server is equipped with one Wide Ultra2 SCSI channel.
■ Be sure to remove all terminating jumpers from third-party
SCSI devices.