Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

Cabling Guidelines 4-5
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: e-ch4 Cabling Guidelines.doc Last Saved On: 12/27/00 3:27 PM
Connecting an Integrated Wide Ultra2 SCSI
Controller to an Internal SCSI Hard Drive or
Other SCSI Device
The following steps detail the procedure for connecting cables from an
integrated Wide Ultra2 SCSI controller to an internal SCSI hard drive or other
device:
1. Follow the steps in the sections following “Installing a Hard Drive” or
“Installing a Tape Drive or Other Device into a Removable Media Bay”
in Chapter 3.
2. Make sure the SCSI ID is uniquely set for each device.
3. Locate the Wide Ultra2 SCSI cable connected to the SCSI connector.
4. Install the next available connector to the hard drive or SCSI device.
5. Install the next available power connector to the hard drive or SCSI
device.
Figure 4-4. Cabling an integrated Wide Ultra2 SCSI controller to a hard drive
or other device