Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide

4-10 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Jennifer Hayward Project: Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide Comments:
Part Number: 173868-002 File Name: e-ch4 Cabling Guidelines.doc Last Saved On: 12/27/00 3:27 PM
Connecting an Integrated ATA/100 Controller to
an Internal ATA Hard Drive or Other Device
The following steps detail the procedure for connecting cables from an
integrated ATA/100 controller to an internal ATA hard drive or other device:
1. Follow the steps in the sections following “Installing a Hard Drive” or
“Installing a Tape Drive or Other Device into a Removable Media Bay”
in Chapter 3.
2. Make sure that the jumper on the drive is set to Cable Select.
3. Locate the ATA cable connected to the primary ATA connector on the
Server Feature Board. If both connectors 0 and 1 of the primary ATA
cable are already connected to installed devices, locate the secondary
ATA cable. The secondary ATA cable is connected to the secondary
ATA connector on the Server Feature Board.
4. Install cable connector 0 of the cable to the hard drive or ATA device. If
cable connector 0 is already connected to an installed device, use cable
connector 1.
IMPORTANT: Make sure that all devices are connected to the ATA cables in the
following order: primary cable connector 0, primary cable connector 1, secondary
cable connector 0, secondary cable connector 1.
5. Install the next available power connector to the hard drive or ATA
device.
Figure 4-9. Cabling an integrated ATA/100 controller to a hard drive or other
device