Quick Setup with Red Hat Linux 7.1 on the Compaq ProLiant ML330 and ProLiant ML330e Servers

"Quick Setup" with Red Hat Linux 7.1 on the Compaq ProLiant ML330 and ProLiant ML330e Servers 8
1528-0501A-WWEN
LILO configuration
Figure 3 LILO Configuration
a. Check the Create Boot disk checkbox (doing this will allow you to boot Red Hat 7.1
from floppy in the event of a system failure).
b. Check the Install LILO checkbox.
c. Check the /dev/hda Master Boot Record (MBR) radio button.
d. Check the Use linear mode (needed for some SCSI drives) checkbox.
e. Check the Default boot image checkbox.
f. Type linux in the Boot label window.
The partition holding your Red Hat Linux root file system will have a Boot label of linux.
If you want to add boot labels for other partitions (or change an existing boot label), click
once on the partition to select it. Once selected, you can change the boot label.
g. Click the Next button.
SMP Motherboards and LILO
If the installation program detects an SMP motherboard on your system, it automatically
creates two lilo.conf entries. The two entries in lilo.conf will be linux and linux-up. Linux
will then boot by default.
9. Setup your network configurations.