HP ProLiant ML350e Gen8 v2 Server Maintenance and Service Guide

Removal and replacement procedures 43
To replace the component, reverse the removal procedure.
DIMMs
To remove the component:
1. Power down the server (on page 25).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the front bezel (on page 26).
4. Place the server on its side.
5. Remove the access panel ("Access panel" on page 26).
6. If installed, remove the PCI air baffle ("PCI air baffle" on page 27).
7. Remove the system air baffle ("System air baffle" on page 28).
8. Open the DIMM slot latches.