HP ProLiant ML350p Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 44
o
Four-bay power supply backplane board
To replace the component, reverse the removal procedure, if the screws are not attached to the backplane
assembly, use the screws provided in the spare backplane assembly kit.
Expansion board
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 27).
o For rack models, if installed, remove the security bezel (on page 27).
2. Power down the server (on page 26).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 28).
5. Remove the access panel ("Access panel" on page 29).
6. Remove the air baffle ("Air baffle" on page 30).