HP ProLiant Gen8 Troubleshooting Guide Volume II: Error Messages

HP Smart Array errors 145
The external Smart Array controller reporting this event is attached to the host
side Smart Array controller <controller name / slot information>.
Message Id: 24762
Severity: Informational
Log message:
External Smart Array controller number <controller number> located in the MSA
chassis labeled as <chassis label> is reporting the following flash operation:
"<firmware message>."
The firmware was flashed from:
Revision: <old revision number>
to
Revision: <new revision number>
The external Smart Array controller is attached to the host side Smart Array
controller <controller name / slot information>.
Message Id: 24763
Severity: Warning
Log message: The external Smart Array controller located in the MSA chassis labeled
as <chassis label> has reported an uncorrectable read error during rebuild
operations for logical drive <logical drive number>. The uncorrectable media
defects are between logical block address <lba number 1> and logical block address
<lba number 2>. The host will be unable to read some blocks between this address
range until the blocks are overwritten. The logical drive rebuild is continuing
so that the volume can regain fault tolerance. Capacity expansion operations must
be avoided while the affected blocks are unreadable.
The external Smart Array controller is attached to the host side Smart Array
controller <controller name / slot information>.
Message Id: 24764
Severity: Warning
Log message :The external Smart Array controller located in the MSA chassis labeled
as <chassis label> is reporting that the <drive type> physical hard drive located
in bay <bay number> is not supported <not supported reason>.
The external Smart Array controller is attached to the host side Smart Array
controller <controller name / slot information>.
<not supported reason> values:
• “because it is a singled ported drive”
• “because it is a SATA drive”
• “because it is smaller than the drive it is replacing”
• “because it is of an unrecognized type”
• “because it contains an unsupported RIS configuration”
Message Id: 24765
Severity: Informational