HP ProLiant Gen8 Troubleshooting Guide Volume II: Error Messages
HP Onboard Administrator errors 172
Insight Display screen shot errors
1 Missing credentials.
2 The getLCDImage CGI process has caught the SIGSEGV signal.
3 Could not acquire access to the image in a reasonable amount of time.
4 Cannot open semaphores.
5 Produce SEMV does not work.
6 Consume SEMV does not work.
7 Cannot lock the image file.
8 Cannot open the image file.
9 Cannot seek in the image file.
10 Unable to resume session.
11 Insufficient privileges.
SysLog messages
These messages are sent to the Onboard Administrator System Log and can be viewed using the various
interfaces to the Onboard Administrator.
The types of system log messages are defined as follows:
• LOG_EMERG—system is unusable
• LOG_ALERT—action must be taken immediately
• LOG_CRIT—critical conditions
• LOG_ERR—error conditions
• LOG_WARNING—warning conditions
• LOG_NOTICE—normal but significant condition
• LOG_INFO—informational
Alertmail log messages
Log type: LOG_ERR, Failure type: SW
Alertmail: Calculated invalid enclosure count for topology event
Alertmail: Failed to get initial enclosure status
Alertmail: Failed to read cooling info
Alertmail: Failed to read enclosure info
Alertmail: Failed to read enclosure names
Alertmail: Failed to read enclosure status
Alertmail: Failed to read event from mgmt subsystem
Alertmail: Failed to read LCD status
Alertmail: Failed to read powersupply measurements