HP ProLiant Gen8 Troubleshooting Guide Volume II: Error Messages

HP Onboard Administrator errors 190
OA: Momentary Press virtual command enacted on blade [value:bladeNumber] by user
[value:username].
OA: Onboard Administrator in bay [value:bayNumber] was restarted by user
[value:username].
OA: Power limit was set to [value] by user [value:username]
OA: Power savings mode was set to [ON/OFF] by user [value:username]
OA: Power subsystem redundancy mode was set to [value] by user [value:username]
OA: Press and Hold virtual command enacted on blade [value:bladeNumber] by user
[value:username].
OA: Reboot virtual command enacted on blade [value:bladeNumber] by user
[value:username].
OA: Session on interconnect [value:bayNumber] cleared by [value]
OA: Standby Onboard Administrator flashed successfully
OA: Virtual power command enacted on interconnect [value:number] by user
[value:username]
OA: Warning: Not all VC-Enet modules are on the same VLAN ID
Log type: LOG_ERR, Failure type: Info
OA: Not possible to get the actual VC Mode of the enclosure.
Linux log messages
Log type: LOG_NOTICE, Failure type: Info
OA: Authentication failure for user [username] from [remote host] requesting
[value]
OA: Authentication failure for user [username] from Enclosure Link requesting
[value]
OA: Authentication failure for user [username] on [value].
OA: Authentication failure for user [username] on the OA KVM.
OA: Authentication failure for user [username] on the OA serial console.
OA: Authentication failure for user [username] requesting [value]
Management log messages
Log type: LOG_EMERG, Failure type: SW
OA: Internal System Firmware Error, Rebooting.
Log type: LOG_WARNING, Failure type: HW
OA: A port mismatch was found with server blade bay [value:bladeNumber] and
interconnect bay [value:slotNumber]
OA: Temperature of I/O module in slot [value:slotNumber] is at alert level
Log type: LOG_WARNING, Failure type: SW
OA: iLO in bay [value] has not responded to the previous [value:count] capping
requests from the Enclosure Dynamic Power Cap.
Log type: LOG_CRIT, Failure type: HW