HP ProLiant Gen8 Troubleshooting Guide Volume II: Error Messages

HP Onboard Administrator errors 199
LDAP: error manipulating password
Log type: LOG_ERR, Failure type: SW
LDAP: bad username [value:username]
LDAP: couldn't obtain coversation function [value]
Log type: LOG_NOTICE, Failure type: SW
LDAP: authentication failure; [value] for [value] service, not a member of any
configured group
LDAP: could not recover authentication token
Redundancy log messages
Log type: LOG_WARNING, Failure type: SW
Redundancy: Active Onboard Administrator has lost link connectivity on the
external NIC for [value] seconds. Forcing take over
Redundancy: Failed to read event from mgmt subsystem
Redundancy: Onboard Administrator is switching to Active mode
Redundancy: Onboard Administrator is switching to Standby mode. This OA will now
reboot
Log type: LOG_CRIT, Failure type: HW
Redundancy: Onboard Administrator redundancy failed to initialize properly. Try
rebooting the Onboard Administrator by reseating the OA module in its bay. If
the problem persists, please call HP support.
Log type: LOG_CRIT, Failure type: SW
Redundancy: Caught Signal SIGSEGV
Redundancy: redund: Failed to startup threads
Log type: LOG_ERR, Failure type: HW
Redundancy: Failed automatic Onboard Administrator failover as a result of
network link loss on the Active OA board
Log type: LOG_ERR, Failure type: SW
Redundancy: Couldn't get random seed
Redundancy: Error communicating via ethernet with the other Onboard Administrator
(heartbeat).
Redundancy: Error communicating via ethernet with the other Onboard Administrator
(timeout).
Redundancy: Error communicating with the other Onboard Administrator.
Redundancy: Failed to get enclosure network
Redundancy: Failed to read OA bay number
Redundancy: Failed to read OA status
Redundancy: Other ([Standby/Active]) OA firmware: v[value:version] - This OA
([Standby/Active]) firmware: v[value:version]
Redundancy: Please upgrade to the latest firmware using [this/the other] Onboard
Administrator which is the active