Compaq ProLiant ML530 Setup and Installation Guide

4-18 Compaq ProLiant ML530 Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Tricia Acevedo Project: Compaq ProLiant ML530 Setup and Installation Guide Comments:
Part Number: 139006-002 File Name: e-ch4 Configuration and Utilities.doc Last Saved On: 6/12/00 4:14 PM
The Integrated Management Log requires Compaq Operating
System-dependent drivers. Refer to the section “Loading Compaq Device
Drivers,” earlier in this chapter, for instructions on installing the appropriate
drivers.
Multiple Ways of Viewing the Log
You can view an event in the Integrated Management Log (IML) in several
ways:
■ From within Compaq Insight Manager
■ From Novell NetWare IML Viewer program
■ Using the Windows NT IML Viewer program
Compaq Insight Manager
Compaq Insight Manager is a server management tool providing in-depth
fault, configuration and performance monitoring of hundreds of Compaq
servers from a single management console. System parameters that are
monitored describe the status of all key server components. By being able to
view the events that may occur to these components, you can take immediate
action. You can view and print the event list from within Insight Manager by
following the instructions below. You can also mark a critical or caution event
as repaired after the affected component has been replaced. For example, when
a fan that has failed has been replaced, you can lower the severity of the event
by marking it as repaired.
Viewing the Event List
1. Select the appropriate server from Compaq Insight Manager, then select
View Device Data.
The selected server is displayed with buttons around its perimeter.
2. Select the Recovery button.
3. Select Integrated Management Log.
4. If a failed component has been replaced, select the event from the list;
then select Mark Repaired.
NOTE: You can only view the event list from the Recovery/Integrated Management Log
screen. To print the list, follow the instructions below.