Compaq ProLiant ML530 Setup and Installation Guide

3-28 Compaq ProLiant ML530 Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Tricia Acevedo Project: Compaq ProLiant ML530 Setup and Installation Guide Comments:
Part Number: 139006-002 File Name: d-ch3 Installation.doc Last Saved On: 6/15/00 9:02 AM
Attaching the Cable Management Arm
A double-hinged cable management arm and fasteners ship with each server.
The cable management arm attaches to the server’s cable management arm
bracket and to the rear frame of the rack. All cables to and from the server are
tied to this arm. The two hinges allow the cable management arm with
attached cables to swing out of the way when you need to access the server
pullout trays.
1. For easier handling, first slide the server into the rack, then attach the
cable management arm to the cable management arm bracket. If you
attach the arm before loading the server in the rack, the arm may swing
around and interfere with the loading process.
2. After you have loaded the server into the rack, attach one end of the
cable management arm to the server’s cable management arm bracket
using two thumbscrews. Align the arm to the bracket as shown in the
following figure.
Figure 3-20. Attaching the cable management arm to the cable management
arm bracket